How to replace a scratched Glass Stove Top
A glass cooktop is straightforward to wash due to its flat surface. you'll simply wipe down the glass to get rid of any spills, but they are doing require special cleaners to avoid damage. They used radiant heat coils or halogen lamps to heat the cooking surface. While the glass-topped stove is meant to face up to damage from cookware, you'll still accidentally scratch or break the cooktop. In some instances, this damage requires replacing the glass top.
Pull your stove out from the wall to access the facility cord and unplug it. If your stove is hardwired to the circuit, close up the breaker dedicated to the stove inside the breaker panel.
Open the oven door. Look beneath the front lip of the glass stove top for the screws securing the highest to the stove body. Use a Phillips screwdriver to get rid of the screws from the stovetop and place the screws aside. BOOK@Gas stove repair home service
Lift abreast of the front of the glass stovetop. Use a wooden rod to carry the stovetop in an “open” position.
Look for the screws on all sides of the cross braces that hold the burners to the underside of the glass stovetop. Use a nut driver to get rid of the hex-head screws holding the braces in situ. Carefully lower the braces and burners to the stove.
Remove the wooden rod holding the glass stovetop. Lower the highest until you'll pull it from the slots dig the rear panel of the stove beneath the instrument panel.
Lay the old top face-down on the ground on top of a blanket or towel. Remove the hex-head screws holding the brackets onto the stovetop. Turn the old glass top over to access the 2 brackets along the rear of the highest. Use a nut driver to get rid of the screws and brackets.
Place the replacement glass stove (Check Out Gas Stove Repair Service in Pune) top face-down on the ground on top of a blanket or towel. Install the brackets you faraway from the old stovetop onto the new one. Secure the brackets with the hex-head screws you far away from the old top. Turn the replacement top face-up.
Lift the new top into place over the stove. Insert the rear brackets into the slots beneath the instrument panel.
Raise the new top, and secure it within the “open” position with the wooden rod. Position the burners and therefore the cross braces against the underside of the new glass stovetop. Use the hex-head screws you faraway from the old stovetop to secure the cross braces and burners to the new top.
Carefully lower the highest and rest it on the stove body. Open the oven door and secure the new glass top to the stove with the Phillips head screws you far away from the first top. Plug the stove into the wall or activate the dedicated breaker.
0 Comments